Mackie MR5 Bedienungsanleitung

> F = 4 A ½ B  < 0 = D 0 ; .3High Resolution Active Studio Monitor

10MR5MR5Repair For warranty repair or replacement, refer to the war-ranty information on page 15. Non-warranty repair for Mackie products is avail-a

11Owner’s ManualOwner’s ManualAppendix B: CONNECTORSXLR ConnectorsXLR connectors are used to make balanced connec-tions to the MR5. They are wired as

1MR5MR5Appendix C: TECHNICAL INFORMATIONEqualizationLow Frequency EQ: +2 dB/+4 dB @ 100 Hz, shelvingHigh Frequency EQ: ±2 dB @ 5 kHz, shelvingAC

1Owner’s ManualOwner’s ManualThe following are trademarks or registered trade-marks of LOUD Technologies Inc.: The Mackie logo, MR Series, Zero Edge

14MR5MR5INPUT SETTINGSLOW FREQFILTERHIGH FREQFILTER0(BALANCED)(BALANCED)(UNBALA NC ED)–2dB+2dB+2dB+4dBCAUTION: REPLACE WITH THE SAME FUSE AND RATING.

15Owner’s ManualOwner’s ManualMR5 Limited WarrantyA. LOUD Technologies Inc. warrants all materials, workmanship and proper operation of this product f

16220 Wood-Red Road NE • Woodinville, WA 98072 • USAUnited States and Canada: 800.898.3211Europe, Asia, Central and South America: 425.487.4333Middle

MR5MR51. Read these instructions. 2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Do not use this apparatus near

Part No. SW0567 Rev. B 01/08 ©2007-2008 LOUD Technologies Inc. All Rights Reserved.Owner’s ManualOwner’s ManualDon’t forget to visit our

4MR5MR5INTRODUCTION• The connecting wires between the amplifier outputs and the drivers are kept to an absolute minimum, so the damping factor of the

5Owner’s ManualOwner’s ManualQUICK STARTWe realize that you can’t wait to hook up your new Mackie MR5 Studio Monitors and try them out. Neverthe-less,

6MR5MR5REAR PANEL DESCRIPTION . INPUT LEVELThe MR5 expects a line-level signal at its input. Use this control to adjust the sensitivity of the input

7Owner’s ManualOwner’s Manual5. Power SwitchUse this switch to turn on or off the MR5. When the power switch is turned on and the MR5 is plugged into

8MR5MR5PROTECTION CIRCUITSInput Signal WiringYou should use high-quality, shielded cable to connect the signal source to the SIGNAL INPUT jack [1] on

9Owner’s ManualOwner’s ManualAppendix A: SERVICE INFONo Sound• Is the power indicator [8] on the front panel illumi-nated? If not, refer to “No Power