Mackie SR1522Z Bedienungsanleitung

1SR1522z REPAIR MANUAL

10 High Frequency Driver replacement: 1 Follow steps 1-4 of the led PCB replacement instructions, as the grill will need to be removed in order to

11High Frequency Driver replacement continued: 6 This is what it looks like with the grill and horn removed. See the next page for further instructio

12High Frequency Driver replacement continued: 8 Keep the four nuts, four locking washers, and four fl at washers in a safe place. 7 Four nuts and ei

1310 Four headless screws need to be removed from the high frequency driver. Pliers could help if the screws are too tight. Turn counter-clockwise to

14 3 The horn assembly is shown above with the high frequency driver circled. Four screws need to be removed from the driver using the 3mm allen wrenc

15 7 This is what the diaphragm (left) and plate adapter (right) both look like. Place the new diaphragm (part # coming soon) where the old one was. F

16 Amplifi er Assembly replacement: 1 Fourteen screws need to be removed from the amplifi er assembly using the phillips head screwdriver. The

17Amplifi er assembly replacement continued: 4 Once the two cover plates are removed, two more screws need to be taken out in order to separate the amp

18Amplifi er assembly replacement continued: 6 Closeups of the led PCB cable and connector are shown above. The black wire of the cable is closest to t

19 8 Place the new amplifi er assembly (part #0014138-00) where the old one was. Follow the same steps as above, but backwards 7 to 1. Remove the seria

2These instructions are intended to help restore any ailing SR1522z Active Loudspeaker back to factory working conditions. They show how to remove and

3Led PCB replacement: 3 Carefully begin to remove the grill. The grill has a tendency to want to “pop out,” so please be sure to hold the grill in pla

4Led PCB replacement continued: 6 Carefully remove the led PCB assembly from the back side of the grill. 7 The hard part is done, the rest is easy! P

5Bottom woofer replacement: 1 Follow steps 1-4 of the led PCB replacement instructions, as the grill will need to be removed in order to access the bo

6Bottom woofer replacement continued: 6 The picture to the right shows what the SR1522z looks like with the grill and bottom woofer removed. Place the

7Top woofer replacement: 1 Follow steps 1-4 of the led PCB replacement instructions, as the grill will need to be removed in order to access the top w

8Top woofer replacement continued: 5 The positive (solid blue) and negative (solid black) cables are still attached to the woofer terminals. Remove th

9 * The grill support (located just above screws 7 and 8 and outlined below) does not need to be taken off in order to remove and replace the top woo