Mackie SA1532Z Bedienungsanleitung

1SA1532z REPAIR MANUAL

10 High Frequency Driver replacement: 1 Follow steps 1-4 of the led PCB replacement instructions, as the grill will need to be removed in order to

11High Frequency Driver replacement continued: 5 The positive (solid blue) and negative (blue and black) cables are still attached to the high frequen

12High Frequency Driver replacement continued: 7 This is what it looks like with the grill and horn removed. See right side for further instructions

13 9 Keep the four screws and locking washers in a safe place. High Frequency Driver replacement continued:11 Turning the high frequency driver ove

14 3 A closeup of the high frequency driver is shown above. Four screws need to be removed from the driver using the 3mm allen wrench. 4 Keep the fou

15 Mid Frequency Driver replacement: 1 Follow steps 1-6 of the high frequency driver replacement instructions, as the grill and horn assembly will

16 4 The mid frequency driver cover plate should easily lift right off of the horn. Holding down the horn assembly with one hand while lifting up on t

17 6 Keep the four screws and locking washers in a safe place. 7 The mid frequency driver easily lifts right off of the horn. Replace with the new

18 Amplifi er Assembly replacement: 1 Eighteen screws need to be removed from the amplifi er assembly using the phillips head screwdriver. The

19Amplifi er assembly replacement continued: 4 Once the two cover plates are removed, two more screws need to be taken out in order to separate the amp

2These instructions are intended to help restore any ailing SA1532z Active Loudspeaker back to factory working conditions. They show how to remove and

20Amplifi er assembly replacement continued: 6 Closeups of the led PCB cable and connector are shown above. The black wire of the cable is closest to t

21 8 Place the new amplifi er assembly (part #0013841-00) where the old one was. Follow the same steps as above, but backwards 7 to 1. Remove the seria

3Led PCB replacement: 3 Carefully begin to remove the grill. Do not fully remove the grill as the cable is still fi rmly attached to the led PCB assemb

4 6 Carefully remove the led PCB assembly from the back side of the grill.Led PCB replacement continued: 7 The hard part is done, the rest is easy! Pl

5Bottom woofer replacement: 1 Follow steps 1-4 of the led PCB replacement instructions, as the grill will need to be removed in order to access the bo

6Bottom woofer replacement continued: 6 The picture on the right shows what the SA1532z looks like with the grill and bottom woofer removed . Place th

7Top woofer replacement: 1 Follow steps 1-4 of the led PCB replacement instructions, as the grill will need to be removed in order to access the top w

8Top woofer replacement continued: 4 Keep the eight screws and fl at washers in a safe place. 5 Carefully begin to remove the woofer. A fl at head scre

9 7 The picture on the left shows what it looks like with the grill and top woofer removed . Place the new woofer (part #0013917) where the old one wa