Mackie SA1232 Bedienungsanleitung

1SA1232z REPAIR MANUAL

10High Frequency Driver replacement continued: 5 The positive (solid blue) and negative (blue and black) cables are still attached to the high frequen

11High Frequency Driver replacement continued: 7 This is what it looks like with the grill and horn removed. See right side for further instructions

12 9 Keep the four screws and locking washers in a safe place. High Frequency Driver replacement continued:11 Turning the high frequency driver ove

13 3 A closeup of the high frequency driver is shown above. Four screws need to be removed from the driver using the 3mm allen wrench. 4 Keep the fou

14 Mid Frequency Driver replacement: 1 Follow steps 1-6 of the high frequency driver replacement instructions, as the grill and horn assembly will

15Mid Frequency Driver replacement continued: 5 Four screws and locking washers may be removed from the mid frequency driver using the phillips head s

16 Amplifi er Assembly replacement: 1 Eighteen screws need to be removed from the amplifi er assembly using the phillips head screwdriver. The

17Amplifi er assembly replacement continued: 4 Once the two cover plates are removed, two more screws need to be taken out in order to separate the amp

18Amplifi er assembly replacement continued: 6 Closeups of the led PCB cable and connector are shown above. The black wire of the cable is closest to t

19 7 Place the new amplifi er assembly (part #0013840-00) where the old one was. Follow the same steps as above, but backwards 6 to 1. Remove the seria

2These instructions are intended to help restore any ailing SA1232z Active Loudspeaker back to factory working conditions. They show how to remove and

3Led PCB replacement: 3 Carefully begin to remove the grill. Do not fully remove the grill as the cable is still fi rmly attached to the led PCB assemb

4 6 Carefully remove the led PCB assembly from the back side of the grill.Led PCB replacement continued: 7 The hard part is done, the rest is easy! Pl

5Bottom woofer replacement: 1 Follow steps 1-4 of the led PCB replacement instructions, as the grill will need to be removed in order to access the bo

6Bottom woofer replacement continued: 6 The picture on the right shows what the SA1232z looks like with the grill and bottom woofer removed . Place th

7Top woofer replacement: 1 Follow steps 1-4 of the led PCB replacement instructions, as the grill will need to be removed in order to access the top w

8Top woofer replacement continued: 6 The picture on the right shows what the SA1232z looks like with the grill and top woofer removed. Place the new w

9 High Frequency Driver replacement: 1 Follow steps 1-4 of the led PCB replacement instructions, as the grill will need to be removed in order to