Mackie MR8 Bedienungsanleitung

> F = 4 A ½ B  < 0 = D 0 ; .3High Resolution Active Studio Monitor

10MR8MR8Repair For warranty service, please refer to the warranty information on page 15. Non-warranty service for Mackie products is avail-able at

11Owner’s ManualOwner’s ManualAppendix B: CONNECTORSXLR ConnectorsXLR connectors are used to make balanced connec-tions to the MR8. They are wired as

1MR8MR8Appendix C: TECHNICAL INFORMATIONEqualizationLow Frequency EQ: +2 dB/+4 dB @ 100 Hz, shelvingHigh Frequency EQ: ±2 dB @ 5 kHz, shelvingAC

1Owner’s ManualOwner’s ManualThe following are trademarks or registered trade-marks of LOUD Technologies Inc.: The Mackie logo, MR Series, Zero Edge

14MR8MR8INPUT SETTINGSCAUTION: REPLACE WITH THE SAME FUSE AND RATING. DISCONNECTSUPPLY CORD BEFORE CHANGING FUSE.ONLOW FREQFILTERHIGH FREQFILTER0–2dB+

15Owner’s ManualOwner’s ManualMackie Limited WarrantyPlease keep your sales receipt in a safe place.This Limited Product Warranty (“Product Warranty”)

16220 Wood-Red Road NE • Woodinville, WA 98072 • USAUnited States and Canada: 800.898.3211Europe, Asia, Central and South America: 425.487.4333Middle

MR8MR8IMPORTANT SAFETY INSTRUCTIONS1. Read these instructions. 2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Do

Part No. SW0568 Rev. D 01/09 ©2007-2009 LOUD Technologies Inc. All Rights Reserved.Owner’s ManualOwner’s ManualDon’t forget to visit our w

4MR8MR8INTRODUCTION• The connecting wires between the amplifier outputs and the drivers are kept to an absolute minimum, so the damping factor of the

5Owner’s ManualOwner’s ManualQUICK STARTWe realize that you can’t wait to hook up your new Mackie MR8 Studio Monitors and try them out. Neverthe-less,

6MR8MR8REAR PANEL DESCRIPTION . INPUT LEVELThe MR8 expects a line-level signal at its input. Use this control to adjust the sensitivity of the input

7Owner’s ManualOwner’s Manual5. Power SwitchUse this switch to turn on or off the MR8. When the power switch is turned on and the MR8 is plugged into

8MR8MR8PROTECTION CIRCUITSInput Signal WiringYou should use high-quality, shielded cable to connect the signal source to the SIGNAL INPUT jack [1] on

9Owner’s ManualOwner’s ManualAppendix A: SERVICE INFONo Sound• Is the power indicator [8] on the front panel illumi-nated? If not, refer to “No Power