Mackie 408S Bedienungshandbuch

OWNER’S MANUALEFXMONHI12kHzHI12kHzMID2.5kHzMONMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHz

10EFXMONHI12kHzHI12kHzMID2.5kHzMONMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMI

11EFXMONHI12kHzHI12kHzMID2.5kHzMONMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMI

12EFXMONHI12kHzHI12kHzMID2.5kHzMONMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMI

13EFXMONHI12kHzHI12kHzMID2.5kHzMONMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMI

14FEATURES AND CONTROLS3-Band EQThe PPM Series has 3-band equalization atcarefully selected points — LOW shelving at80Hz, MID peaking at 2.5kHz, and H

15EFX SendThis taps the channel’s signal out to eitherthe internal EMAC Digital Stereo EffectsProcessor or to an external device via theEFFECTS SEND j

16EFX WIDEDepending on the effect selected, thisswitch adds more width or depth to the effect.Note that it doesn’t work with the DELAY andPHASER effec

17DelaysThere are four delays available. Delay 1 hasone repeat after the original note. Delay 2 hastwo repeats, Delay 3 has three, and Delay 4 hasfour

18TIME/RATE PARAMETERIf you have a reverb effect selected, thiscontrol adjusts how long the reverberationlasts, with 0 being a short reverb time and 1

19EFX TO MONUse this control to add the EMAC internaleffects (or external effects, if connected) to themonitor mix. The effects signal is added to the

CAUTION AVISRISK OF ELECTRIC SHOCK DO NOT OPENRISQUE DE CHOC ELECTRIQUENE PAS OUVRIRCAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCKDO NOT REMOVE COVE

20not hurt most dynamic mics. Check the micro-phone’s user manual if you’re not sure.Caution: Turn all outputlevels down before operat-ing this switch

21POWER switchThe POWER switch is located on the rearpanel of the mixer, near the linecord socket.Switch up to turn the mixer on, and switchdown to tu

22SLEEVE (SHIELD)TIP (HOT)TIPSLEEVETIPSLEEVEUnbalanced 1/4" TS PlugThe INSERT jack can also be used as a di-rect out from the mic preamps to tape

23EFFECTS SEND and RETURNEFX FOOTSWITCHRIGHT RETURNLEFT RETURNSENDEFFECTS(OVERRIDES INTERNAL EFX)The EFFECTS SEND jack is a 1/4" connectorthat pr

24When a 1/4" plug is inserted in the POWERAMP IN jacks, the internal connection betweenthe mixer section and the amplifier section iscut.This co

25SPEAKER OUTOUTPUT POWER: 250 WATTS / CHANNELMINIMUM SPEAKER LOAD: 2 OHMS / CHANNELSPEAKER OUTLEFT / MAINRIGHT / MONITORPOWERTW 120 VAC 60HZ 320WONSP

26GENERAL PRECAUTIONS AND CONSIDERATIONSNEVER bypass the ACplug’s ground pin. This isdangerous!It is recommended that a stiff (robust)supply of AC pow

27APPENDIX A: Service Info• Is the channel’s VOLUME control andthe MAIN MASTER control properly set?Refer to the “Level Setting Procedure” onpage 6.•

28The bass frequencies diminish whenstanding center, but get louder as youapproach one side!• Check the polarity of the speaker cableconnections. You

29Unbalancing a LineIn most studio, stage, and sound reinforce-ment situations, there is a combination ofbalanced and unbalanced inputs and outputson

3Lend Me Your EarsExposure to extremelyhigh noise levels may causepermanent hearing loss.Individuals varyconsiderably insusceptibility to noise-induce

30TS phone plug. The balanced-to-unbalancedconnection has been anticipated in the wiringof Mackie jacks. A 1/4" TS plug inserted into a1/4"

31Maximum Input LevelsMic Input: –20 dBu, Trim @ 0 dB (HI)+20 dBu, Trim @ –40 dB (LOW)Line Input: 0 dBu, Trim @ 0 dB (HI)+40 dBu, Trim @ 40 dB (LOW)In

32Power Amplifier SectionMaximum Power at 1% THD, midband, bothchannels driven406M, 408M, 408S250 watts per channel into 2Ω200 watts per channel into

33Block DiagramsPPM Series Powered MixersStereo Versions (408S, 808S)63 1252505001K2K4K8K 16KDAMPING/DEPTHTIME/RATEEFX WIDE1050-5-10-15-30-40-20dBLRMI

34Mono Versions (406M, 408M, 808M)63 1252505001K2K4K8K 16KEFX RET LEFX RET REFX WIDE1050-5-10-15-30-40-20dBLRMID HI80 2K5 12KLO75HzHPF1050-5-10-15-30-

35NOTES

®®®™Mackie Designs Inc.Mackie Designs Inc.16220 Wood-Red Rd. NE • Woodinville, WA 98072 • USAUS & Canada: 800/898-3211Europe, Asia, Central &

4INTRODUCTION406M 408M 808M 408S 808S6 Mono Channels ✓ ✓ ✓ ✓ ✓2 Mono/Stereo Channels ✓* ✓* ✓ ✓Pan Controls ✓ ✓Effects

5Don’t forget to visit our website at www.mackie.comfor more information about these and other Mackie products.®CONTENTSLend Me Your Ears ...

6READ THIS PAGE! QUICK STARTWe know you can’t wait toget your new mixer set upand working. Who has timeto read the manual? Butplease, take a moment to

7EFXMONHI12kHzHI12kHzMID2.5kHzMONMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID

8EFXMONHI12kHzHI12kHzMID2.5kHzMONMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID

9EFXMONHI12kHzHI12kHzMID2.5kHzMONMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID2.5kHzMONHI12kHzMID