Mackie MR8MK2 Bedienungsanleitung

OWNER’S MANUALHigh Resolution Powered Studio Monitor MR8mk2

10MR8mk2MR8mk2Repair For warranty service, please refer to the warranty information on page 15. Non-warranty service for Mackie products is availab

11Owner’s ManualOwner’s ManualXLR ConnectorsXLR connectors are used to make balanced connections to the MR8mk2. They are wired as follows, according

12MR8mk2MR8mk2Appendix C: Technical InformationAC Power RequirementsUS: 120 VAC, 60 Hz Europe: 240 VAC, 50 Hz Korea: 220 VAC, 60 Hz

13Owner’s ManualOwner’s ManualThe following are trademarks or registered trademarks of LOUD Technologies Inc.: The Mackie logo, MR Series and the Run

14MR8mk2MR8mk2CAUTION: REPLACE WITH THE SAME FUSE AND RATING. DISCONNECTSUPPLY CORD BEFORE CHANGING FUSE.LOW FREQFILTERHIGH FREQFILTER0–2dB+2dB+2dB+4d

15Owner’s ManualOwner’s ManualMackie Limited WarrantyPlease keep your sales receipt in a safe place.This Limited Product Warranty (“Product Warranty”)

16220 Wood-Red Road NE • Woodinville, WA 98072 • USAUnited States and Canada: 800.898.3211Europe, Asia, Central and South America: 425.487.4333Middle

2MR8mk2MR8mk21. Read these instructions. 2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Do not use this apparatus

Part No. SW0894 Rev. C 08/11 ©2011 LOUD Technologies Inc. All Rights Reserved.3Owner’s ManualOwner’s ManualDon’t forget to visit our website at www.

4MR8mk2MR8mk2Introduction• In addition, the ampliers’ gain and frequency responses are individually hand-trimmed to compensate for typical manufa

5Owner’s ManualOwner’s ManualQuick StartWe realize that you can’t wait to hook up your new Mackie MR8mk2 Studio Monitors and try them out. Neverthele

6MR8mk2MR8mk2Rear Panel Description2. INPUT LEVELThe MR8mk2 expects a line-level signal at its input. Use this control to adjust the sensitivity of th

7Owner’s ManualOwner’s Manual5. POWER SWITCHSwitch up to turn the MR8mk2 on. Make sure the level control is down before you turn it on. When the power

8MR8mk2MR8mk2Protection CircuitsInput Signal WiringYou should use high-quality, shielded cable to connect the signal source to the signal input jack [

9Owner’s ManualOwner’s ManualAppendix A: Service InformationNo Sound• Is the power indicator [8] on the front panel illuminated? If not, refer to “N